Home/News/DuPont MOLYKOTE® L-8033 Semi-Dry Lubricant: A Quick-Drying, Low-Residue Lubrication Solution for Plastic Sliding Parts
DuPont MOLYKOTE® L-8033 Semi-Dry Lubricant: A Quick-Drying, Low-Residue Lubrication Solution for Plastic Sliding Parts
November 19, 2026
As 3C electronics, office equipment, and precision instruments continue to trend toward lightweight and miniaturized designs, engineering plastics and elastomers are increasingly used in sliding structures. Conventional greases in such applications often attract dust, migrate, or prove incompatible with certain plastics. DuPont MOLYKOTE® introduces L-8033 Semi-Dry Lubricant—a system based on perfluoro oil, PTFE, and a fluoro solvent. After application, it forms a non-sticky semi-dry film that balances plastic compatibility with wide-temperature stability, providing clean and durable friction reduction for sliding parts in cameras, printers, copiers, fax machines, and similar equipment.
Product Highlights
Composition: Perfluoro oil + polytetrafluoroethylene (PTFE) + fluoro solvent, supplied as a liquid dispersion for brush or dip application.
Film behavior: Dries to a pink, semi-dry film that is not sticky like grease, offering wide surface coverage and low residue.
Temperature range: −60 °C to 150 °C, covering cold-start conditions to continuous operation in typical office equipment.
Plastic compatibility: 1/4 oval test confirms no cracking on POM, PS, and ABS.
Friction coefficient: 0.08 for both POM-vs-PS and POM-vs-steel, enabling smooth sliding and squeak suppression.
Environmental profile: Zero Ozone Depletion Potential (ODP); Global Warming Potential (GWP) lower than equivalent MOLYKOTE® products; fluoro solvent system with no flash point.
Packaging & shelf life: Available in 1 kg cans (50 g samples available); usable life of 36 months from date of production when stored in original unopened containers at or below 40 °C (104 °F).
Why Semi-Dry, Not Fully Dry
Conventional dry-film lubricants often require baking to cure. In contrast, L-8033 relies on fast-evaporating fluoro solvent and forms a thin semi-solid film immediately after coating—retaining the low-soiling advantage of solid lubricants while maintaining a slight oil phase for boundary lubrication. For components such as printer paper-path mechanisms, camera zoom rings, and copier plastic guides near fuser units—areas that "cannot take grease but cannot run fully dry either"—this semi-dry form is cleaner than grease and easier to apply than baked dry films.
Application Fit
Office equipment: Sliding rails and cams in printers, copiers, and fax machines—reducing squeak and dust pickup.
AV & precision instruments: Camera zoom and focus rings, DVD tray rails, optical fine-adjustment mechanisms.
Generic plastic assemblies: Low-cost friction points where POM, PS, or ABS slide against steel or against each other.
Market tailwind: Industry reports note steady growth in demand for dry and semi-dry lubricants within 3C precision components and clean assembly lines, with environmental regulations driving a gradual shift from oil-based systems toward low-VOC semi-dry alternatives.
Handling & Compliance Note
Clean the contact surface before application; brush or dip coating is sufficient. The TDS explicitly states that product safety information required for safe use is not included in the document—users must read the Safety Data Sheet (SDS) and container labels prior to handling. This product has not been validated for medical or pharmaceutical applications and should not be extrapolated to implantable devices or drug-delivery equipment. DuPont also notes that typical values presented are not intended for preparing specifications; end-use validation under actual operating conditions is essential before mass production